What is factory jumper settings?
You may have pins on the back of your hard drive that nothing is connected to. These pins are called jumpers, and are used to enable specific types of settings. The settings these jumpers enable are hard-coded onto a drive’s programmed printed circuit board.
How do I setup my WD internal hard drive?
Installing a WD hard drive takes just a few simple steps.
- Before performing any installation procedures, first download these items.
- Open your computer.
- Mount the drive in a 3.5″ device bay.
- Attach the SATA or PATA interface cable (not included).
- Secure the drive with the four screws provided.
How do you put a jumper on a SATA hard drive?
Four-Pin Seagate SATA Drives
- Locate the jumper block on the back of the Seagate SATA hard drive.
- Place the jumper over the first and second pin on the right to limit the drive’s data transfer to 1.5 Gigabits per second when it is being used in a server or multi-drive desktop with slow hard drives.
What is the function of jumper?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers.
How do I change my jumper settings?
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated. A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered.
Why is my hard drive not showing up?
If your new harddisk is not detected by or Disk Manager, it could be because of a driver issue, connection issue, or faulty BIOS settings. These can be fixed. Connection issues can be from a faulty USB port, or a damaged cable. Incorrect BIOS settings may cause the new hard drive to be disabled.
What is the use of jumper setting?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping.
What are the jumper settings for Western Digital?
SPECIFICATIONS | Western Digital WD10EADS Caviar Green 1TB SATA. Western Digital WD10EADS Caviar Green 1TB SATA 3Gb/s Hard Drive. Jumper block: 8-pin (no Master/Slave settings) 10-pin (single, Master, Slave, and cable select (CSEL. If you change the setting of jumper 7 – 8, you will lose all previous data and the.
Where is the jumper block on a Western Digital hard drive?
Support Hard Drives – Western Digital Jumper Settings | Those Reviews That You Need. All Caviar drives have a jumper block (J8) located between the 40-pin IDE connector and the power connector. These jumpers select options physical hard disk detection.
Where to place jumper shunt on Western Digital caviar drive?
For your other drive, consult its installation guide for master/slave configuration. To designate the Caviar drive as the MASTER, place a jumper shunt across pins 5-6. To designate the Caviar drive as the SLAVE, place a jumper shunt across pins 3-4.
What are the pins on the Western Digital J8 jumper block?
The pins on the J8 jumper block must be configured for the dual installation. If the other device connected to the IDE cable is not an IDE drive from Western Digital, see the installation guide on the master / slave configuration. See Figures 1 or 2 to determine its configuration.