Recommendations

How do I get my Onkyo receiver out of standby mode?

How do I get my Onkyo receiver out of standby mode?

How to Reset Onkyo Protect Mode

  1. Unplug the receiver’s power cord from the wall and leave unplugged for at least one hour.
  2. Reconnect the power cord after at least one hour has passed.
  3. Turn the receiver on and turn the volume to the maximum setting.
  4. Turn the volume back to the minimum setting and turn off the receiver.

What is auto standby Onkyo?

Auto Standby This function places the unit on standby automatically after 20 minutes of inactivity without any video and/or audio input.

What is Hybrid Standby on Onkyo receiver?

Hello. The Hybrid Standby light indicates that there is a feature that is being utilized by the receiver while in “Standby Mode”.

Is there a reset button on Onkyo receiver?

Hold down the “VCR/DVD” button and, with another finger, press the “On/Standby” button. You should see “Clear” appear on the receiver’s display before it goes into standby mode.

Why is my Onkyo remote not working?

Make sure you have selected the correct remote controller mode. Make sure to set the same ID on both the unit and remote controller. Operating other Onkyo component by using a RI remote control code is not available. Make sure that the Onkyo component is properly connected with RI cable.

What is standby mode on a receiver?

You can set the receiver to switch to standby mode automatically when you do not operate the receiver or when no signals are input to the receiver. When you set [On], the receiver switches to standby mode after approximately 20 minutes. …

How do I reset my Onkyo remote control?

To reset all the remote controller settings: While holding down RECEIVER, press and hold Q for 3 or more seconds until the remote indicator stays lit. Within 30 seconds, press RECEIVER again. Resetting is complete when the remote indicator flashes twice.

How do I get my Sony receiver out of standby mode?

Select [Settings] – [System Settings] from the home menu. Select [Auto Standby]. Set [On] or [Off]. When you set [On], the receiver switches to standby mode after approximately 20 minutes.